Nikon Camera F50 - Manual (Page 27)

Using Built-In Flash
Use the built-in flash not only
when the ready-light blinks, but
also when your subject is in
shadow or backlit.
See pages 51 to 55.
24
J
// au I o Rewind
When the film reaches the end of the roll, auto rewind begins.
During rewinding, O and li blink in the LCD panel. After rewind
automatically stops, frame counter shows
E
and
0
blinks for a
few seconds. You can then remove film cartridge.
• When battery power is very weak, or when the temperature is
very low, film may not rewind at the end of roll and Err appears
in the LCD panel. In this case, replace battery with a fresh one,
or wait for the temperature to rise and then press the rewind
button.
To rewind film at mid-roll: Press the rewind button on the
camera bottom.
V
J