Installing bahery – Nikon Camera F50 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLING BAHERY
I
Make sure the camera’s power
is off, then slide the lock
release on the battery chamber
cover to open the chamber.
2
Insert a 6V lithium pack with
“+” and ends positioned as
shown on the inside of the cover.
Close the cover by pushing until it
clicks.
»Use 6V lithium battery pack (2CR5 or DL245 type).
•See page 62 for “NOTES ON BATTERIES”.
3
Switch the power ON. Check
the LCD panel to see if the
frame counter shows "E" or the
frame number appears and no
battery mark or '=') appears.
I f b l i n k s ; Battery is nearing
exhaustion. Have a fresh one
ready.
If Err and '=' blink: Battery is almost
exhausted. Switch power OFF and
replace battery with fresh one.
If no indication appears on the
LCD panel: Battery is completely
exhausted or improperly installed.
Change the battery.