Nikon 58-104 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8
Pressing the shutter release button
slightly
Check the flash shooting distance
range and be sure the ready-light and
the (•) in-focus indicator are lit up.
—If the electronic analog display appears,
the operation is controlled by center-
weighted TTL flash. In this case, the main
subject is taken at the correct exposure,
but it the electronic analog display is on
the plus side, the background exposure
will be too bright (over-exposed), or if it is
on the minus side, the background expo
sure will be too dark (under-exposed). If
no special background effects are
needed, the photograph can be taken as
is with correct exposure.
For matrix balanced fill-flash operation,
reset the aperture dial on the camera so
that the overexposure or underexposure
indicator goes out. Using the exposure
calculation chart (see page 41), be sure
the aperture value set is within the
shooting distance range.
Shooting
If both viewfinder ready-light and
SB-104 ready-light blink for about
three seconds after shooting, the
flash has operated at maximum
power.
—In this case, either reduce the object
distance, or select a smaller f-number.
27