Removing / replacing the throat plate, Adjustments – Craftsman 315.228390 User Manual

Page 34

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ADJUSTMENTS

REMOVING / REPLACING THE THROAT

PLATE
See Figure 44.

WARNING: Make sure the switch is off, the
switch key is removed, and your saw is

unplugged. Failure to do so could result in

accidental starting, resulting in serious personal

injury,

■ To remove the throat plate, first loosen the screw in

the throat plate with a phillips screwdriver and lift
the front end. Pull it out toward the front of the saw.

■ To re-install the throat plate, place it in the opening.

Push it toward the rear of saw base to engage the

spring clip.

Note: The keyslot in the throat plate will drop over the

screw.

■

Check that the throat plate is even with the table
top. If not, adjust the four set screws with a 2
mm hex key. See the procedure in the Assem
bly seciion.

■ Securely tighten throat plate screw. Do not allow

the throat plate to bow up above the table surface.

THROAT PLATE

CRAFTSMAN* TABLE SAW 315.228390