Craftsman 315.228390 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SMALL PARTS LIST

Check all loose parts from the box with the list and figures below and on the previous pages. Small items such
as fasteners and end caps are shown in figure 2 c. Follow the instructions in the Assembly section to assemble
your new saw.

O. Hardware for Rail, Front......................................... 1

square head bolt (5/16-18 x 1 in..)..........................6

flat washer (5/16 in.)............................................... 6

hex nut (5/16-18).................................................... 6

end cap for front rail................................................2

screw (#8-32 x 1/2 in.)............................................ 2

(§)

Hardware For Rail, Rear....................................... 1

square head bolt (5/16-18 x 1 in.)...........................6

flat washer (5/16 in.)............................................... 6

hex nut (5/16-18).................................................... 6

end cap for rear rail................................................ 2

screw (#8-32 x 1/2 in.).... ..................... .................. 2

Qms>

Y. Hardware for Blade Guard Bracket and Blade Guard

Assembly

Blade Guard Bracket.............................................. 1

hex cap screw (5/16-18 x 1/2 in.)........................... 2

lock washer (5/16 in.)..............................................2

Blade Guard Assembly........................................... 1

socket head cap screw (1/4-20 x 3/8 in.)................3

flat washer (1/4 in.)..................................................3

3s® @

Hardware for Mounting Switch Assembly

square nut (1/4-20)................................................. 2

screw (1/4-20 x 3/8

in.)..................................... 2

screw (#10-24 x 3/8

in.)..................................... 2

cord clip...................................................................2

Fig. 2 c

Note: Cord clip and screw mount to the either side of

saw cabinet and are used to secure motor
cord, depending upon operator preference of
switch assembly.

CRUFTSMIIN'TABLE SAW 315.228390