Craftsman 315.228390 - Manual (Page 21)

ASSEMBLY
Note: The right side of saw is on your right when
facing the saw, as if you were in normal
operating position.
INSTALLING THE REAR RAIL
See Figures 12- 14.
WARNING: Front and rear rails must be
installed and carefully aligned to reduce the risk
of kickback. Kickback can result in serious injury.
■ From the carton, remove the rear rail pieces and
the following hardware:
6 square head bolts (5/16-18 x 1 in.)
6 flat washers (5/16 in.)
6 hex nuts (5/16-18)
Rear rail connector
Right and left end caps for rear rail
2 screws (#8-32 x 1/2 in.)
Note: Remaining hardware from this hardware bag is
used for installing the front rail and end caps.
■ At the back of the table, put the square head bolts
in the holes in the edge of the saw table and the
outer holes in each extension table so the bolt
heads extend outward 1/2 in.
■ Under the table, loosely attach washers and hex
nuts onto bolts. Slide the slot on the rear rail over
the bolts. Adjust each bolt to fit the rail closely to
the table.
■ Position right rail (longest piece) so that right hand
edge extends 2-1/2 inches beyond table extension.
■ Push right rail against table and tighten each nut
with a 12 mm wrench. If rail jams and does not
slide easily over bolts, re-align table extensions.
■ Put the end caps on rail ends. Insert the screws
and tighten with a phillips head screwdriver.
TABLE
EXTENSION
REAR RAIL
SQUARE
HEAD BOLTS
SQUARE
HEAD BOLTS
HEX NUT
FLAT
WASHER Fig. 12
HEX NUT
REAR RAIL
REAR RAIL
CONNECTOR Fig. 13
2-1/2 in.
REAR RAIL
21
SCREW
REAR OF SAW Fig. 14
CRBFTSMHN’TABLE SAW 315.228390