beautypg.com

O)©

Page 11: 3lm! (§), O)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SMALL PARTS LIST

Check all loose parts from the box with the list on the previous page, the figures below and on the following
page. Small items such as fasteners and end caps are shown in figures 2 b and 2 c. Follow the instructions in
the Assembly section to assemble your new saw.

F.

Hardware for Handwheel...................................... 2

screw (#10-24 x 1/2 in.).......................................... 2

flat washer (#10) .................................................... 2

3lM! (§)

V, Hardware for Mounting Motor, Motor Mounting

Plate, and Belt Guard

Hardware for Mounting Motor............................... 1

hex bolt (5/16-18 x 1 in.).........................................4

flat washer (5/16 in.).............................................. 8

lock washer (5/16 in.) ...................... ...................... 4

hex nut (5/16-18).................................................... 4

(o)©

Hardware for Motor Mounting Plate....................... 1

hex bolt (5/16-18x3/4 in.)........................................ 2

Hardware for Belt Guard....................................... 1

hex nut (#10-24)..................................................... 4

flat washer (#10) .................................................... 4

@

W. Hardware for Table Extensions............................ 1

hex bolt (5/16-18 x 1 in.)................ ....................... . 8

flat washer (5/16 in.)............................................ 16

hex nut (5/16-18).................................................... 8

O)

X. Hardware for Leg Stand, Leveling Feet, and

Mounting Saw Base

Hardware for Leg Stand .......................... .............. 1

carriage bolt (5/16-18 x 3/4 in.) ........................... 24

flat washer (5/16 in.)............................................. 24

hex nut (5/16-18).................................................. 24

Hardware for Leveling Feet.................................. 1

leveling foot............................................................ 4

flat washer (5/16 in.)............................................... 8

hex nut (5/16-18)................................................ 8

9

O (Q

Hardware for Mounting Saw Base.......................... 1

hex bolt (5/16-18 x 3/4 in.)...................................... 4

flat washer (5/16 in.)............ ....................... ........... 8

hex nut (5/16-18).....................................................4

9

o)

Fig. 2 b

11

CnnFTSMflN* TABLE SAW315.228390

See also other documents in the category Craftsman Power saws: