Unpacking instructions (see figure 1), Unfold the handlebars (see figure 2), Check all nuts and bolts for tightness – Craftsman 987.799601 User Manual

Page 8: Assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY

Read these Instructions in their entirety before you attempt to assemble your new chipper/vac. Your new chipper/vac
has been completely assembled at the factory, except for the items shown in Figure 1. To ensure proper operation of
your chipper/vac, all nuts and bolts must be securely tightened when changing the configuration of the machine Use
the correct tools as necessary to ensure proper tightness.

UNPACKING INSTRUCTIONS (see Figure 1)

1, The following items are contained in the shipping
carton and shown in Figure 1;

(A) Chipper/Vac

{B)

Safety Goggles

{D)

Collection Bag

Check for missing or damaged parts. If any parts are

missing or damaged, contact your local Sears service

center or Sears retail outlet for assistance.

IMPORTANT: MOTOR OIL AND GASOLINE MUST BE

ADDED TO THE ENGINE BEFORE THE ENGINE IS

STARTED. THE PROCEDURES FOR ADDING

MOTOR OIL AND GASOLINE ARE ON PAGES 18

AND 19.

NOTE; Ail references to the front, rear, left and right of

the machine are determined as follows;

The inlet cap for the optional vacuum hose is located on

the front of the machine. The discharge opening is at
the rear The left and right sides are determined by

standing at the rear of the machine when the handlebars
are in the “vacuum" position

UNFOLD THE HANDLEBARS (see Figure 2)

1. Squeeze the handlebar end {with decal “Push in
Here”) toward the center of the machine to release end
from the notch in the mounting bracket (C) and swing the
handlebars up over the machine toward the rear.

2. Position the handlebar ends in the “vacuum” notches
of the brackets (D in Figure 2 inset).

3. Unfold the handlebars until the channels on the upper

left and right handlebars are aligned with the lower
handlebars (A). If necessary, loosen knobs (B) before

unfolding handlebars

4. Tighten the knobs

(B)

CHECK ALL NUTS AND BOLTS FOR

TIGHTNESS

Check all nuts and bolts for tightness following assembly
and according to the schedule given in the section which
describes "Customer Responsibilities" on Page 27.

NOTE: Do not overtighten the bolts which attach the

engine mounting plate to the housing. DAMAGE TO
THE HOUSING COULD RESULT