Assembly – Craftsman 987.799601 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY

A CAUTION

• Check Ihe collection bag frequently for deterioration

and wear and replace worn bags.

STEP 2: INSTALL COLLECTION BAG

For walk-behind vacuuming or using the chipper, install

the collection bag as described below.

1. Stop the engine, disconnect the spark plug wire
from the sparkplug, and make sure that ail moving

parts have come to a complete stop.

2. Make sure the bag

in Figure 4) is zipped,

3. Piace the collection bag straps over the handlebars.

Line up the tabs on the bag inlet adapter (B) with the

slots in the discharge opening

(C)

and slide the bag inlet

adapter down ait the way into the slots. Turn the
retaining knob (F) until the tab on the knob drops into the
slot on the top of the bag inlet adapter

Figure 4: instali collection bag.

NOTE: The'rod

(D)

on the inlet adapter is part of the

machine’s safety interlock system. Make sure that the

rod fitssecurely in the slot in the safety interlockswiich

(E),

BAG MAINTENANCE TIP: Keep the bag clean by

occasionally washing it (by hand) with mild soap and
water, A clean bag improves air flow and resuits in
better vacuuming performance. Do not wash the bag in
an automatic washer Do not use a cleaner which
contains bleach. Allow the bag to dry thoroughly before
storing.

STEP 3: ADJUST THE VACUUM INLET HEIGHT

The vacuum inlet height can be adjusted to six different
settings in approximately 1/2" increments. These
settings allow inlet suction to be adjusted for varying

needs. For example, when vacuuming deep layers of
leaves, adjust the vacuum inlet height at the front of the
machine to its highest setting as described below (see
Figure 5):

1. Stop the engine, disconnect the spark plug wire
from the sparkplug, and make sure that all moving

parts have come to a complete stop.

Squeeze the adjuster lever

in Figure 5) toward the

wheel to disengage the adjuster pin from the hole in the

height adjuster bracket.

Rotate the adjuster lever toward the rear (discharge

opening) of the machine to raise the height and then

release the adjuster lever so that the adjuster pin
engages the selected hole in the bracket. Rotate the
lever in the opposite direction to lower the inlet height

Be sure that both adjuster levers are adjusted to the

same height

Figure S: Vacuum Height Adjustment Lever and inlet Cap.

STEP 4: INSTALL VACUUM INLET CAP

1, Posfion the inlet cap {B, Figure 5) so that the bar on

the cap is aligned with the arrow at the REMOVE

position.

*2. Twist the cap 1/4 turn clockwise which will secure the

cap in place