Assembly, Assembly for optional vacuum – Craftsman 987.799601 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
ASSEMBLY FOR OPTIONAL VACUUM
liwOC UHCrlAi ILliM
NOTE; The options! Vscuurn Hose is desiQned for
stationary vacuuming operation only.
STEP 1: MOVE HANDLEBARS TO VACUUMING
POSITION
1. Stop the engine, disconnect the spark ping wire
from the spark plug, and make sure that all moving
parts have come to a complete stop.
2. Squeeze the handlebar end {A in Figure 11 inset with
decal “Push in Here") toward the center of the machine
to release end from the notch in the mounting bracket
and swing the handlebars up over the machine toward
the rear,
3. Position the handlebar ends in the “vacuum” notches
of the brackets (B in Figure 11 Inset),
STEP 2: REMOVE BLOWER DEFLECTOR (IF
INSTALLED)
Turn retaining knob
(D
in Figure 12) untii the tab on the
knob is out of the slot in the blower deflector. Pull the
sides of the blower deflector
(A
in Figure 12) out of the
slots in the discharge opening
(B
) and slide the blower
deflector off the machine.
Handleliars in Vacuum
Position
Figure 11: Handlebar position for vacuuming.
Figure 12: Remove blower deflector.
14