Craftsman 536.881800 - Manual (Page 9)

ASSEMBLY
NOTE: If the cables have become dis­
connected, connect cables as shown in
Figure 7.
Traction Drive Cable Auger Drive Cable
Figure 7
HOW TO ASSEMBLE THE CHUTE DEFLECTOR
1. Remove the
carriage bolt.
See
Figure 8.
2. Raise the chute deflector into op­
erating position,
3. Fasten
chute deflector
to
flange
with
carriage bolt.
Make sure to
install with head of carriage bolt on
the inside of the flange.
4. Fasten with
washer
and
locknut.
5. Tighten locknut securely.
NOTE: Make sure all carriage
bolts In flange are tight. DO NOT
OVERTIGHTEN.
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing. To adjust the skid
height for different conditions, see To
Adjust Skid Height paragraph in the
Service And Adjustment
section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory
and no adjustments should be neces­
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose, if an adjust­
ment is necessary, see “How To Check
And Adjust The Cables” in the Service
And Adjustment section.
F-0410108L