Service and adjustment – Craftsman 536.881800 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENT
HOW TO REMOVE
THE SNOW HOOD
To access the spark plug, the snow
hood must be removed as follows:
1. Remove the choke control knob
(see Figure 21).
2. Remove the
safety key.
3.
Remove the
mounting screws
(see Figure 22).
4. Slowly remove the snow hood.
Make sure that the
primer button
hose
and the
ignition wire
are not
disconnected.
5. The
spark plug
can now be ac
cessed.
6. To install the snow hood, first make
sure that the primer button hose
and the ignition wire are connected.
7. Mount the snow hood to the engine
and secure with the mounting
screws (see Figure 22).
8. Connect the choke control knob
with the choke shaft on the carbure
tor (see Figure 23 and Figure 24).
Make sure the choke control knob is
properly installed. If the choke con
trol knob is not Installed correctly,
the choke will not operate.
9. Install the
safety key.
Cont'oVkncb
Mounting Screws
Snow Hood
A
JUm
icnitio'h Wire
ittoi
3 M
Figure 22
PriTer Button
-fi
■
M
Choke
Control Knob
' I
Choke Shaft
Figure 23
} ’mg
Figure 21
Safety Key
F-0410108L