Checklist, Assembly – Craftsman 536.881800 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
y"
All assembly instructions have been
completed.
y
The discharge chute rotates freely.
y
No remaining loose parts in carton.
y
Check the fasteners. Make sure all
fasteners are tight.
y
Check the air pressure of the tires.
Correct air pressure is from 14 to 17
PSI. See the side of the tire for maxi
mum inflation. Do not exceed maxi
mum inflation.
y
On electric start models, the unit was
shipped with the starter cord plugged
into the engine. Before operating, un
plug the starter cord from the engine.
While learning how to use your snow
thrower, pay extra attention to the fol
lowing important items:
y
Engine oil is at proper level. Use a
high
quality
detergent
oil
classified
“For Service SG, SH, SJ, SL, or
higher”.
y
Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline
with a minimum of 85 octane.
y
Become familiar with all controls-
their location and function. Operate
controls before starting engine.
F-0410108L
10