Craftsman 536.881800 - Manual (Page 18)

MAINTENANCE
CUSTOMER RESPONSIBILITIES
SERVICE RECORDS
Fill in dates as you
complete regular
Before
Each
Use Often
Every
8
Hours
Every
25
Hours
Every
50
Hours
Every
100
Hours
Each
Season
Before
Storage
Check Engine Oil Level V....
Change Engine Oil
Ti ghten M Screws and
Nuts...............................
Check and Clean Spark
Plug
Replace Spark Plug
Clean and Inspect
Spark Arrestor
Lubricate Chute Control
Flange...........................
■V '
Check Fuel
V
Check Adjustment of
Auger Control Cable
Auger Drive Beit
Check Tire Pressure
* Adjust after 2 to 4 hours of use,
GENERAL RECOMMENDATIONS
The warranty on this snow thrower does
not cover items that have been subjected
to operator abuse or negligence. To re­
ceive full value from the warranty, the op­
erator must maintain the snow thrower as
instructed in this manual.
Some adjustments will need to be made
periodically to properly maintain your
snow thrower.
Maintenance, replacement, or repair of the
emission control devices and systems can
be performed by any non-road engine re­
pair establishment or individual. Regular
maintenance will improve the performance
and extend the life of the engine.
A WARNING; Do not strike the
flywheel with a hammer or a
hard opject. If done, the fly­
wheel can shatter during operation.
Do not tamper with the governor
spring, links or other parts to in­
crease engine speed.
F-0410108L IE
AFTER EACH USE
• Run the machine to clear the auger
of snow.
• To prevent freezing of the auger or
controls, remove all snow and slush
from the snow thrower.
• Check for any loose or damaged
parts.
• Tighten any loose fasteners.
• Check and maintain the auger.
• Check controls to make sure they
are functioning properly,
• If any parts are worn or damaged,
replace immediately.