Craftsman 917.27103 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHbOTING CHART
PROBLEM
CAUSE
CORRECTION
Wiil not start
• Out of fuel
» Fill fuel tank.
» Engine not “CHOKED” prop-
eHy.
- See ‘TO START ENGINE" in
Operation section.
» Engine flooded*
■ Wait several minutes before
attempting to start.
« Bad spark plug*
• Replace spark plug.
• Dirty air filter.
• ftrty fuel filter,
• Water In fuel.
• Clean/replace air filter.
• Replace fuel filter.
• Drain fuel tank and carburetor,
refill tank with fresh
gasoline and replace fuel filter.
* Check all wiring.
• Loose or damaged wiring.
• Carburetor out of adjustment
* See 'To Adjust Carburetor” in
Service and Adjustments
section.
-
* Engine valves out of adjust
ment
» Contact an authorized service
center.
Hard to start
» Dirty air filter.
• Ciean/replace air filter.
• Bad spark plug.
» Replace spark plug.
• Weak ortdead battery.
" Recharge or replace battery.
• Dirty fuel filter.
• Replace fuel filter.
0
stale or dirty fuel.
• Drain fuel tank and refill with
fresh gasoline.
« Loose or damaged wiring.
• Check all wiring.
• Carburetor out of adjustment.
• See ‘To Adjust Carburetor” in
Service and Adjustments
section.
• Engine valves out of adjust
ment
» Contact an authorized service
center.
Engine will not turn
over
» Clutch/brake pedal not
depressed.
* Depress clutch/brake pedal.
• Attachment clutch Is engaged.
“ Disengage attachment clutch.
» Weak or dead battery.
« Recharge or replace battery.
• Blown fuse.
“ Replace fuse.
• Corroded battery terminals.
• Clean battery terminals.
» Loose or damaged wiring.
• Check all wiring.
• Faulty ignition switch.
» Check/replace ignition switch.
» Faulty solenoid or starter.
• Check/replace solenoid or
starter.
» Faulty operator presence
switch(es).
• Contact ah authorized service
center.
.................... —
-----------
i
-------------- --
Engine dicks but will
* Weak or dead battery.
• Recharge or replace battery.
not start
» Corroded battery terminals.
• Clean battery terminals.
» Loose or damaged wiring.
" Check all
Wiring.
» Faulty solenoid or starter.
« Check/replace solenoid or
starter.
Loss of power
• Gutting too much grass/too
fast.
• Set in “Higher Cuf posi-
tion/reduce speed.
• Throttle in “CHOKE” position.
• Adjust throttle control.
28