Craftsman 917.27103 - Manual (Page 21)

TO SERVICE CARTRIDGE.
Replace a dirty, bent, or damaged car­
tridge.
NOTE: Do not wash the paper cartridge
or use pressurized air, as this will damage
the cartridge.
* Reinstall the pre-cleaner (cleaned and
oiled) over the paper cartridge.
® Reassemble air cleaner, wing nut, cover
and tighten knob securely.
CLEAN AIR INTAKeCOOLING AREAS
To insure proper cooling, make sure the
grass screen, cooling fins, and other
external surfaces of the engine are kept
clean at all times.
Every 100 hours of operation (more often
under extremely dusty, dirty conditions),
remove the blower housing and other
cooling shrouds- Clean the cooling fins
and external surfaces as necessary. Make
sure the cooling shrouds are reinstalled.
NOTE: Operating the engine with a
blocked grass screen, dirty or plugged
cooling fins, and/or cooling shrouds re­
moved will cause engine damage due to
overheating.
ENGINE OIL FILTER
Replace the engine oil filter every season
or every other oil change if the tractor is
used more than 100 hours in one year.
» Drain oil from engine crankcase (See
‘TO CHANGE ENGINE OIL” in this sec­
tion of this manual, through step remove
drain plug).
* Remove oil filter and wipe off filter
adapter.
* Apply a thin coating of new engine oil to
the rubber gasket on replacement oil fil­
ter.
® install replacement oil filter on filter
adapter. Turn oil filter clockwise until
rubber gasket contacts the filter
adapter, then tighten filter an additional
1/2 turn.
® Fill crankcase with new oil (See ‘TO
CHANGE ENGINE OIL" in this section
of this manual). For approximate capac­
ity see “PRODUCT SPECIFICATIONS”
on page X of this manual.
« Start the engine and check for oil leaks.
Correct any leaks before placing engine
into full operation.
Oil Filter
MUFFLER
Inspect and replace corroded muffler and
spark arrester (if equipped) as it could cre­
ate a fire hazard and/or damage.
SPARK PLUGS
Replace spark plugs at the beginning of
each mowing season or after every 100
hours of operation, whichever occurs first.
Spark plug type and gap setting are
shown in “PRODUCT SPECiFICATiONS”
on page 5 of this manual.
IN-LINE FUEL FILTER
The fuel filter should be replaced once
each season. If fuel filter becomes
clogged, obstructing fuel flow to carbure­
tor, replacement is required.
® With engine cool, remove filter and plug
fuel line sections.
» Place new fuel filter in position in fuel
line with arrow pointing towards carbu­
retor.
® Be sure there are no fuel line leaks and
clamps are properly positioned.
CLEANING
« Clean engine, battery, seat, finish, etc.
of all foreign matter.
« Keep finished surfaces and wheels free
of all gasoline, oil, etc,
» Protect painted surfaces with automo­
tive type wax.
We do not recommend using a garden
hose to clean your tractor unless the elec­
trical system, muffler, air filter and carbu­
retor are covered to keep water out. Water
in engine can result in a shortened engine
life.
21