beautypg.com

Craftsman 917.27103 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

approximately 2-1/2 inches during the
cool season and to over 3 inches during

hot months. For healthier and better
looking lawns, mow often and after
moderate growth,

« For best cutting performance, grass

over 6 inches in height should be
mowed twice. Make the first cut rela­
tively high; the second to desired height.

TO OPERATE MOWER
Your tractor Is equipped with an operator

presence sensing switch. Any attempt by

the operator to leave the seat with the

engine running and the attachment clutch
engaged will shut off the engine,

® Select desired height of cut.
® Lower mower with attachment lift con­

trol.

® Start mower blades by engaging attach­

ment clutch control.

® TO STOP MOWER BLADES - disen­

gage attachment clutch control.

CAUTION: Do not operate the mower

without either the entire grass catcher, on
mowers so equipped, or the discharge
guard in piace.guard in place.

Attachment Clutch Attachment Lift

TO OPERATE ON HILLS

^CAUTION: Do not drive up or down
hills with slopes greater than 15“ and do
not drive across any slope,

« Choose the slowest speed before start­

ing up or down hills,

« Avoid stopping or changing speed on

hills.

« If slowing is necessary, move throttle

control lever to slower position.

» If stopping is absolutely necessary, push

clutch/brake pedal quickly to brake posi­
tion and engage parking brake.

® Move gearshift lever to 1 st gear. Be

sure you have allowed room for tractor

to roll slightly as you restart movement.

® To restart movement, slowly release

parking brake and clutch/brake pedal.

® Make all turns slowly.

TO TRANSPORT

» Raise attachment lift to highest position

with attachment lift control.

* When pushing or towing your tractor, be

sure gearshift lever is in neutral (N)
position.

» Do not push or tow tractor at more than

five (5) MPH.

NOTE: To protect hood from damage
when transporting your tractor on a truck
or a trailer, be sure hood is closed and
secured to tractor. Use an appropriate
means of tying hood to tractor {rope, cord,
etc.).

TOWING CARTS AND OTHER

ATTACHMENTS

Tow only the attachments that are recom­

mended by and comply with specifications
of the manufacturer of your tractor. Use
common sense when towing. Too heavy of
a load, while on a slope, is dangerous.
Tires can lose traction with the ground and
cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

« The engine in your tractor has been

shipped, from the factory, already filled
with summer weight oil.

* Check engine oil with tractor on level

ground,

® Unthread and remove oil fill cap/dip-

stick; wipe oil off. Reinsert the dipstick
into the tube and rest oil fill cap on the
tube. Do not thread the cap onto the
tube. Remove and read oil level. If nec­
essary, add oil until “FULL” mark on

dipstick is reached. Do not overfill.

® For cold weather operation you should

change oil for easier starting (See “OIL
VISCOSITY CHART” in the Customer

Responsibilities section of this manual).

» To change engine oil, see the Customer

Responsibilities section in this manual.

ADD GASOLINE
® Fill fuel tank. Use fresh, clean, regular

unleaded gasoline with a minimum of 87

octane. {Use of leaded gasoline will

increase carbon and lead oxide

deposits and reduce valve life). Do not

mix oil with gasoline. Purchase fuel in

15