Ezfit, Additional tasks, Notes – Sony SPP-S9000 User Manual
Page 10: If the battery becomes weak during a call, Note, To erase the last phone number dialed, Tone), Flash ), Redialing 1, Talk
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EZfit
The "KZfit” adjusts to lit any shape ear.
thereby ensure clear voice reception.
Additional tasks
To
Do this
Adjust the handset
volume
Set the VOL switch to H (high). M (middle) or L (low).
Switch to tone
dialing temporarily
Press
(*TONE)
after vou're connected.
The line will remain in tone dialing until disconnected.
Switch to another
call (“call waiting
service”*)
Press (
FLASH ).
Press the button again to get back to the first caller.
• Contact your telephone company to subscribe to this service.
Notes
• When you increase the sound volume, in some cases the back ground noise may be increased as well.
You should adjust the volume accordingly.
• If the handset beeps every second during conversation, move closer to the base unit; otherwise, the call
will be disconnected after one minute.
Tip
You can save battery power by setting the RING switch on the
bottom to OFF.
The handset won’t ring, but you can still make calls. You can also
receive calls if another telephone connected to the same line rings
to inform you of incoming calls. However, you cannot page the
handset from the base unit.
RING
switch
If the battery becomes weak during a call
The handset will beep twice per second with the BAIT LOW lamp flashing at the same time.
Finish your call and charge the battery pack.
For optimum performance, charge the battery for a full 12 hours.
Note that during the initial charge time (approx, 10 minutes) the ВАТТ LOW lamp lights up
and the telephone cannot be used.
After the ВАТТ LOW lamp goes off, you may be able to use the phone, but the battery
duration will be very short; thus it is recommended that you fully charge the battery before
next use.
Redialing
1
Press (
TALK
). and wait until the TALK button lights up.
2
Press (
REDIAL)
to redial the number last dialed.
Note
If the number exceeds 32 digits or if it is erased, five short error beeps will alert you that the number cannot
be dialed.
To erase the last phone number dialed
Press (
REDIAL
) twice.
The number will be erased from the memory, and you'll hear a long confirmation beep.