Display messages, On safety, On power sources – Sony MDS-JA3ES User Manual
Page 28: On operation, On the minidisc cartridge, On cleaning, Precautions display messages
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Precautions
Display Messages
On safety
• The use of optical instruments with this product will
increase eye hazard.
• Should any solid object or liquid fall into the cabinet, implug
the deck and have it checked by qualified personnel before
operating it any further.
On power sources
• Before operating the deck, check that the operating voltage
of the deck is identical with your local power supply. The
operating voltage is indicated on the nameplate at the rear of
the deck.
• If you are not going to use the deck for a long time, be sure
to disconnect the deck from the wall outlet. To disconnect
the AC power cord, grasp the plug itself; never pull the
cord.
On operation
If the deck is brought directly from a cold to a warm location,
or is placed in a very damp room, moisture may condense on
the lenses inside the deck. Should this occur, the deck may not
operate properly. In this case, remove the MD and leave the
deck turned on for about an hour until the moisture
evaporates.
On the MiniDisc cartridge
• Do not open the shutter to expose the MD.
• Do not place the cartridge where it will be subject to
extremes of sunlight, temperature, moisture or dust.
On cleaning
Clean the cabinet, panel and controls with a soft cloth slightly
moistened with a mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent such as alcohol or
benzine.
If you have any questions or problems concerning your
deck, please consult your nearest Sony dealer.
The following table explains the various messages that
appear in the display.
Message
Meaning
Blank Disc
A new (blank) or erased MD has been
inserted.
Cannot Copy
An attempt was made to make a second
copy from a digitally dubbed MD (see
page 33).
Cannot EDIT
An attempt was made to edit the MD
during Program or Shuffle Play.
Disc Error
The MD is scratched or missing a TOC.
Disc Full
The MD is full (see "System Limitations"
on page 31).
Impossible
An attempt was made to combine tracks
while playing back the first track.
Name Full
The titling capacity of the MD has reached
its limit (about 1,792 characters).
NO DISC
There is no MD in the deck.
No Track
The inserted MD has a disc title but no
tracks.
Protected
The inserted MD is record-protected.
Retry
The first recording attempt failed due to a
disturbance or scratch on the MD, and a
second attempt is being made.
Retry Error
Due to vibrations to the deck or scratches
on the MD, several recording attempts
were made but with no success.
Sorry
An attempt was made to combine tracks
that cannot be combined.
STANDBY
(flashing)
The contents recorded by timer have
disappeared over time and are not be
available for saving to disc, or Program
Play could not be activated since the
program has disappeared over time.
30