Sony MDS-JA3ES - Manual (Page 12)

Recording on MDs
Recordihg Over Existing Tracks Adjusting the Recording Level
Follow the procedure below to record over existing
material just as you would on an analog cassette tape.
KW AMSOW
i'pS
a $ <5 O
1 Do Steps 1 to 4 in "Recording on an MD" on page 4.
2 Turn AMS (or press or ►►!) until the number
of the track to be recorded over appears.
3 To record from the start of the track, continue from
Step 5 in "Recording on an MD" on page 4.
While "TRACK" flashes in the display
The deck is recording over an existing track, and stops
flashing when it reaches the end of the recorded pxartion.
y'To record from the middle of the track
1 After Step 2 above, press ► to start playback.
2 Press II where you want to start recording.
3 Continue from Step 5 in "Recording on an MD" on page
4.
Note
You cannot record from the middle of an existing track when
the "PROGRAM" or "SHUFFLE" is on.
When recording with INPUT at ANALOG and the
signal input through LINE IN or MIC L(MONO)/R
jack(s) (see page 14), use REC LEVEL to adjust the
2 Play the portion of the program source with the
strongest signal level.
3 While monitoring the sound, turn REC LEVEL to
adjust the recording level so that the peak level
meters reach their highest point without turning on
the OVER indication. Occasional lighting of
"OVER" is acceptable.
The outer knob controls the L (left) channel level
and the inner knob the R (right) channel level.
You can adjust the knobs together, or independently
by turning one knob while holding the other.
"OVER" indication
4 Stop playing the program source.
5 To start recording, do the procedure starting from
Step 7 in "Recording on an MD" on page 5.
12