On moisture condensation, On upgrading the system – Sony PCG-705 User Manual
Page 135
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
□
□
Your computer will not work with party lines, cannot be connected to
a coin-operated telephone, and may not work with multiple phone
lines or a private branch exchange (PBX).
If the telephone company makes a service call to your home or office
and determines that your computer is responsible for a problem, the
telephone company may bill you for the service call. Also, if you do
not disconnect your computer when it is adversely affecting the
telephone line, the telephone company has the right to disconnect
your service until you correct the problem.
On Moisture Condensation
If the computer is brought directly from a cold location to a warm one,
moisture may condense inside your computer. In this case, allow at least
an hour before turning on your computer. If any problems occur, unplug
your computer, and contact your Sony Service Center.
On Upgrading the System
□ The procedures described in “Upgrading Your Notebook Computer”
on page 139 assume familiarity with the general terminology
associated with personal computers and with the safety practices and
regulatory compliance required for using and modifying electronic
equipment.
□ ^Disconnect the system from its power source and from any
telecommunications links, networks, or modems before you open the
system or do any of the procedures described in “Upgrading Your
Notebook Computer”. Failure to do so may result in personal injury
or equipment damage.
Electrostatic discharge (ESD) can damage disk drives and other
components. Perform the procedures described in “Upgrading Your
Notebook Computer” only at an ESD workstation. If such a station is
not available, do not work in a carpeted area, and do not handle
materials that produce or hold static electricity (cellophane wrappers,
for example). Ground yourself by maintaining contact with an
unpainted metal portion of the chassis while performing the
procedure.
□
127