Sony HCD-541 - Manual (Page 26)

Playing in a Desired Order - Program Play
Prass O- to start playback.
T5
The ^ indicator lights up.
Skipping to the next selection programed
Press »1 during playback.
Going back to the beginning of the selection being
played
Press 1« during playback.
To stop program play
Press ■. The last selection number programed will be
displayed.
To resume playback, press D>. Play begins horn the
beginning of the program.
You can play the same program repeatedly as long as you do
not cancel program play or erase the program.
To program while observing the disc labels
You can program the selections with the disc table open.
To check the program contents
Press CHECK. Each time the button is pressed, the program
contents are displayed in the programed order.
To cancel program play
Press CONTINUE and return to the continuous playback
mode. The program will be erased.
To cancel all the selections programed
Press ■ to cancel in stop mode.
If the disc table is opened or the power is turned off, the
program contents are also erased.
To program for recording
After steps 1 to 3-A or 3>B3), press II to insert a pause and
program the selections for side B by performing step 3-A to
3-B3).
When the selections for side A have been played, the unit
will pause. 0^” lights up.)
Set the tape to the beginning of side B, then press ^ or II.
The selections for side B will start playback.
Notes
* The playing time for selection numbers higher than 20 will
not be added into the total playing time.
* When selections have been programed for sides A and B,
the display shows the selections programed for side B and
the total playing time for side B in stop mode.
26