Sony STR-D965 - Manual (Page 10)

Receiver Operations
1 Press one of the SYSTEM CONTROL/FUNCnON
buttons to select the component you want to use.
The SYSTEM CONTROL/FUNCTION buttons on
the remote are factory-set as follows:
To listen to or watch Press
Records PHONO
Radio programs TUNER
Compact discs (CD) CD
Digital Audio Tapes (DAT) DAT/MD
Audio tapes TAPE
TV programs TV
Laser discs LD
Video tapes VIDEO 1 (VHS)
VIDEO 2 (Beta)
VIDEO 3 (8mm)
The receiver and the selected component turn on.
If you want to change the factory setting of a button,
see page 19.
If the component does not turn on
Press the power switch on the component.
2 Start playing.
Refer to "Remote Button Descriptions" on page 27
for details.
To turn off the components
Press SYSTEM OFF. You can turn off the video and audio
components connected to the SWITCHED AC OUTLETS on the
back of this unit at the same time.
y' If you use a Sony TV
When you press TV to watch a TV program, the TV turns
on and switches to the TV input. The TV also turns on
automatically and switches to the appropriate video input
when you press LD, VIDEO 1, VIDEO 2 or VIDEO 3 (STR-
D965 only). If the TV' does not switch to the appropriate
input automatically, press TV/VIDEO on the remote.
Watching TV without the receiver (for Sony TVs only)
Press TV CONTROL ON to set the remote to operate TV
functions only (see "Remote Button Descriptions" on page
26 for details). When you press this button, the TV turns
on and switches to the TV input. If the TV does not
automatically switch to the TV input, press TV/VIDEO.
Receiving Broadcasts
This receiver lets you enter a station's frequency
directly by using the numeric buttons (direct tuning). If
you don't know the frequency of the station you want,
see "Receiving broadcasts by scanning stations"
(automatic tuning).
Before you begin, make sure you have:
• Connected an FM/AM antenna to the receiver as
indicated on page 5.
• Selected the appropriate speaker system. (For details,
see "Selecting the speaker system" on page 7.)
Number
POWER buttons BAND DIRECT
MASTER
VOLUME
1 Press POWER to turn on the receiver.
2 Press TUNER.
The last received station is tuned in.
3 Press BAND to select FM or AM stations.
4 Press DIRECT.
5 Press the numeric buttons to enter the frequency.
Example V. FM 102.50 MHz Example 2; AM 1350 kHz
TZ][oID[iID[ED[oZ:] (You don't have to enter
b b b b b
b b b
6 When you tune in AM stations, adjust the direction
of the AM loop antenna for optimum reception.
To receive other stations
Repeat Steps 3 to 5.
If the STEREO indicator remains off
Press FM MODE even when an FM stereo broadcast is
received.
10
'Q' If an FM stereo program is distorted
The STEREO indicator flashes. Press FM MODE to change
to monaural (MONO). You will not have the stereo effect
but the distortion will be reduced. To return to the auto
stereo mode, press this button again.