Installing the capture board – Sony DVBK-2000 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the capture board
For windows, the capture board corresponds to the
plug & play of Windows 95.
Before installing the capture board, be sure to write
down the five digit serial number from the label on
the capture board. This number is necessary for
registration during the start up procedure.
1
Turn off your PC.
2
Disconnect the power cord from the wall outlet.
Not doing so may cause malfunctions when
connecting the capture board.
3
Open your PC case and remove the cover of PCI
bus slot for inserting capture board.
For details, read the instruction manual for your
PC.
4
Insert the capture board into the slot and put on
screws.
5
Replace the case on your PC.
6
Turn on your PC.
The next procedure depends on your PC.
Read the next page of "Installing the driver" for
Windows.
For Macintosh, proceed to "Installing the DV
software (Macintosh)" (Page 19).