Sony DVBK-2000 - Manual (Page 10)

Installing the capture
board
Notes on installing the board
• Turn off the power on your PC and peripheral
equipment before installation or removal. If you do
not, the DV capture board, PC and peripheral
equipment may be damaged.
• Do not directly touch the components on the board,
or they may be damaged by static electricity. If you
need to touch the board, touch a metal object to
discharge the electricity before you touch the board.
• Be sure that the current consumption of installed
board does not exceed the maximum supplied
current rating. The DV capture board requires a
current of 0.6 A at maximum. If you install other
boards on your PC, refer to each instruction manual
to check how much electrical current is required.
• Do not leave the board on a surface which is prone
to static electricity, for example, on the carpet. This
may damage the board.
• Do not directly touch the connectors on the board.
• The board incorporates sophisticated electronic
parts. Do not drop or damage the board.
• When removing the board from your PC, refer to
the instruction manual for your PC. If you
disconnect it by force, the DV capture board and PC
may be damaged.
• Do not moisten the DV capture board.