Sony CMT-ED1 - Manual (Page 2)

WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical sliock, do not open the cabinet.
Refer servicing to qualified personnel onlv
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
Laser component in this product is capable of
emitting radiation exceeding the limit for Class 1.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER
PRODUCT MARKING is
located on the rear exterior.
This caution label is located inside the unit.
I CLASS 1 LASER PRODUCT Щ
LUOKAN 1 LASERLAITE I
KLASS 1 LASERAPPARAT ■
CAUTION
ACWAR^r
AVUTTHESSA J* SJOJALUKITUS OHITtTTAESSA
DL£T ALTTIINA LAS€RSiTEILVlL£
NOTICE FOR THE CUSTOMERS IN THE
U.S.A.
Ж
CALmON: TO REDUCE TX RISK OP ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABI.£ PARTS INSIDE
REFER SERVICING TO OUALIFIEO SERVICE PERSONNEL
This symbol is intended to alert the
user to the presence of uninsulated
“dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
INFORMATION
This equipment has been testeLl and founLi to
compiv with the limits tor a Class B digital device,
pursuant to Part 13 of the FCC Rules. These limits
are designed to pro\’ide reasonable protection
against harmful interference in a residential
installation. This equipment generate.s, uses, and can
radiate radio frequenc)' energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures;
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio / TV
technician for help.
CAUTION
You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.
Note on CATV system installer:
This reminder is provided to call CATV system
installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.
NOTICE FOR THE CUSTOMERS IN
CANADA
CAUTION:
TO PREVENT ELECTRIC SHOCK, DO NOT USE
THIS POLARIZED AC PLUG WITH AN
EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.
This stereo system is equipped with the Dolby* B-
type noise reduction system.
* Dolby noise reduction manufactured under license
from Dolby Laboratories Licensing Corporation.
“DOLBY" and the double-D symbol □□ are
trademarks of the Dolby Laboratories Licensing
Corporation.