Sony CMT-ED1 - Manual (Page 18)

Playing a tape
You can plav any typo of tape, TYPE I
(normal), TYPE II (CrO:) or TYPE IV (metal).
The deck automatically detects the tape type.
1
Press = PUSH of the front cover
and insert a recorded tape into deck.
With the side you want
to olav facing forward
18
2
Press FUNCTION repeatedly until
"TC" appears.
3
Press DIR MODE on the remote
repeatedly to select ~ " to play one
side or to play both sides.
4
Press O (or TAPE on the
remote),
Press on the remote
again) to play the rever.se side. The tape
starts playing.
The deck stops automatically after playing both
sides five times.
To Do this
Stop play Press □.
Pause Press DO. Press again to
resume play.
Fast-forward
or rewind
During stop press , »OOfl
or IKKKKl {or C> on
the remote).
Find the beginning
of the current or
succeeding track During play, press KKKKl
orl>Ot>t>lI (orlKKl/[>t>fl
on the remote).
Remove
the cassette Press ^ PUSH.
Adjust the volume Press VOLUME +/- (or
VOL -t-/- on the remote).
Tips
• Pressing TAPE on the remote while the
power is off automatically turns on the power and
starts tape playback if there is a tape in the deck
(One Touch Play).
• You can switch from another source to the tape
deck just by pressing TAPE on the remote
(Automatic Source Selection).
• When you want to reduce the hiss noise in low-
level high-frequency signals, press DOLBY NR on
the remote before step 4 so appears.