Sony AV-DV75 - Manual (Page 4)

'W 1
CONNECTIONS
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is 120 V
AC. Check that the rated voltage matches your local voltage.
IMPORTANT
Connect the speakers, antennas, and all other external
equipment first. Then connect the AC cord at the end.
CONNECTING EQUIPMENT
Jacks and plugs of the connecting cord are color-coded as
follows:
Red jacks and plugs: For the right channel of audio signals
White jacks and plugs: For the left channel of audio signals
Yellow jacks and plugs: For video signals
NOTE
Insert the plugs fully into the jacks. Loose connections may
produce a humming sound or other noise interference.
*' Be sure to connect the VIDEO OUT terminal of a DVD player
directly to a TV set, not through this unit. Otherwise, the picture
noise may appear when playing copy protected DVDs.
Input sound through the DIGITAL IN terminals cannot be
recorded. When recording the sound from the DVD, CD, MD
or LD player, connect the analog AUDIO OUT terminals of the
player to the corresponding AUDIO IN terminals of the receiver.
When connecting a monaural video, use a stereo-mono
connecting cord (not supplied).
**
When connecting an LD player equipped with the AC-3 RF
OUT terminal, use an RF demodulator unit. Also connect the
analog AUDIO OUT terminals of the LD player to the receiver
to play all the sources. For further information, refer to the
instructions of the LD player.
DVD or Video 1*^/MD player
to OPTICAL
DIGITAL OUT
(DVD)
• Optical
connecting
cord
to AUDIO IN(Video l/MD)
to VIDEO IN (Video 1)
to AUDIO OUT
to VIDEO OUT(Video 1)
WiiXiAi. fjy
IViDE0 2)
OPTICAL
Coaxial
connecting
cord
Optical
connecting
cord
to COAXIAL
DIGITAL OUT
RF demodulator*'’
Video 2*® or
LD*^/Cable TV
to OPTICAL
DIGITAL OUT
CD
1 1
@ o FnF=fnFil
DVD or MD,CD Player
to AUDIO OUT
ENGLISH