To cancel timer standby mode temporarily, Using the unit whiie the timer is set, Timer recording – Sony AIWA NSX-V50 User Manual

Page 56: Sening the sleep timer, 1 press the sleep button, To cancel the sleep timer, Setting the sleep timer, Setting the timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING THE TIMER

To cancel timer standby mode temporarily

Press the TIMER button on the remote control so that © or

disappears on the display.
To restore the timer standby mode, press again to display 0 or

REC.

Using the unit whiie the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, repeat step 5 to prepare the source,

and adjust the volume and tone.

• Timer playback and timer recording will not begin unless the

power is turned off.

•Connected equipment cannot be turned on and off by the

built-in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with

an external timer) sources only.

Press the TIMER button twice on the remote controi so that

appears on the dispiay, and press the II SET button within

4 seconds. Repeat the steps in page 54 from step 2 and insert
the tape to be recorded into deck 2 after step 5.

SEniNG THE SLEEP TIMER

The unit can be turned off automatically after a specified time

passes.

Use the remote control.

1 Press the SLEEP button.

seconds.

is displayed for 4

2 Within 4 seconds, press the ◄◄ or ►► button to

specify the time untii the power is turned off.

Each time the button is pressed, the time changes between
10 and 240 minutes in 10-minute steps. The specified time

To check the time remaining until the power is turned off

Press the SLEEP button once. The remaining time is displayed

for 4 seconds.

To cancel the sleep timer

Press the SLEEP button twice so that “SLEEP” on the display

disappears.