Other information, Programming the remote control, To program a cable box or a satellite receiver – Sony KP 51HW40 User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Information
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
Sony
Equipment
S mm VCR...............
..............
DVDPli^ei^.............................
Switch Position
on Remote Control
"’iw’i..............................................
.........................................
’"
a
VS............................................
IWD.................................
Programmabie
Code Number
303
i02
”3o’r
7ST”
if you have video equipment other than Sony brand that you want to control
with the projection TV’s remote control, use the following procedures to
program the remote control-
iiidr^
!
From the “Manufacturer’s Codes” listed on page 70, select the three-digit
code number for the manufacturer’s code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1
Open the panel of the remote control.
2
Press CODE SET inside the panel.
3
Close the panel and press SAT/CABLE (FUNCTON).
4
Enter the three-digit manufacturer’s code number using the 0-9 buttons.
5
Press ENTER.
S
To check if the code number works, aim the projection TV’s remote
control at the component and press the green POWER button that
corresponds with that component. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
68