Sony KP 51HW40 - Manual (Page 17)

Installing and Connecting the Projection TV
Cable Box
Connections Cable Box and Cable
This is the preferred basic cable TV hookup to use if:
□ Your cable TV company scrambles some channels, but not ail of them
(pay channels vs. regular cable channels) and you need to use a cable
box, and
□ You want to enjoy the Twin View feature.
With this setup you can:
□ Use the projection TV remote control to change channels using your
cable box when the signal is scrambled.
□ Use the projection TV remote control to change channels using your
projection TV when the signal is not scrambled. (Your projection TV’s
tuner provides a better signal than the cable box.)
□ Use the Twin View feature. (When all channels are routed through your
cable box, only one channel is sent to the projection TV, so you can not
use the Twin View or Channel Index features for your cable box.)
1
Connect the Cable TV cable to the projection TV’s VHF/UHF jack.
2
Using a coaxial cable, connect the projection TV’s TO CONVERTER
jack to the cable box’s IN jack. The projection TV’s internal converter
allows you to switch between unscrambled signals coming straight into
the projection TV and scrambled signals coming in through the cable
box, eliminating the need for an external splitter.
3 Using a coaxial cable, connect the cable box’s OUT jack to the
projection TV’s AUX jack.
3
Í Q
a i
3
Q .
O
o
3
3
3
Í Q
5
m
I
C D
O
Cable box
IN
OUT
AUX
Rear of
projection TV
75-ohm coaxial cable (not supplied)
TO
CONVERTER
I Signal
№
VHF/UHF
CATV cable (unscrambled channels)
;■ ahS^thosb coming diructly
17