Connecting the tv, Cable system or vhf/uhf antenna system, Cable or vhf/uhf (or vhf only) – Sony BRAVIA KDL52V4100 User Manual
Page 12: Hd cable box/hd satellite box, Shown with hdmi connection, Cable system and vhf/uhf antenna system
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Connecting the TV
Cable System or VHF/UHF Antenna
System
You can enjoy high-definition and standard
definition digital programming (if available in
your area) along with standard-definition analog
programming.
• This TV is capable of receiving unscrambled digital
programming for both cable (QAM and 8VSB) and
external VHF/UHF antenna (ATSC).
• It is strongly recommended that you connect the
CABLE/ANTENNA input using a 75-ohm coaxial
cable to receive optimum picture quality. A .700-ohm
twin lead cable can be easily affected by radio
frequency interference, resulting in signal degradation.
Cable or VHF/UHF (or VHF only)
75-ohm coaxial
cable
Rear of TV
CABLE/ANTENNA
HD Cable Box/HD Satellite Box
You can enjoy high-defmition programming by
subscribing to a high-defmition cable service or a
high-definition satellite service. For the best
possible picture, make sure you connect this
equipment to your TV via the HDMI or
component video (with audio) input on the back of
your TV.
Shown with HDMI Connection
Rear of TV
'HomL]E
Cable System and VHF/UHF Antenna
System
Use an optional A-B RF switch (not supplied) to
switch between the cable and over-the-air antenna
programming, as indicated below.
Cable
Antenna
A-B RF switch
Rear of TV
CABLE/ANTENNA
HDMI cable
HD cable box/
HD satellite box
CATV/Satelllte
I
antenna cable
' Be sure to set the
Signal Type
setting to
Cable
or
Antenna
in the
Channel
settings for the type of
input signal you choose (see page .77).
12