Selecting the impedance, Selecting the speaker system, Notes – Sony STR-DA80ES User Manual
Page 9: Tv/vcr hookups, Overview, What cables will i need, V if you want to watch high quality video images, Note, Hookups, Tv or digital broadcasting system (dbs) tuner
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
&
Getting Started
Selecting the impedance
Set the IMPEDANCE SELECTOR for all the speakers
as indicated in the table below. Check the instruction
manual of your speakers if you're not sure of the
impedance^ (This information is usually printed on a
label on the back of the speaker.)
If nominal impedance of
your speaker is
Set IMPEDANCE SELEQOR to
Between 4 arul 8 ohms
40
8 ohms or higher
80
Selecting the speaker system
If you connect only one set of front speakers, set the
SPEAKERS selector on the front panel to A. If you
connect two sets of front spe^ers, see tfie following:
To drive
Set SPEAKERS selector to .
Speaker system A (connected
to the FRONT SPEAKERS A
A
terminals)
Speaker system B (connected
to the FRONT SPEAKERS B
B
terminals)
Bodi speaker systems A and B
(parallel connection)
A+B
Notes
When y k SPEAKERS selector on the hcmt panel to A + B, make sure' • The nominal impedance of the both sets of speakers are 8 ohms or higher. • The IMPEDANCE SELECTOR is set to 4 Q. To connect any speaker pair through an amplifier Connect the amplifier to the PRE OUT jacks of the receiver. TV/VCR Hookups Overview This section describes how to connect video components to the receiver. For digital coimections, see "Digital Component e* TV/DBS’' VIDEO 2 MONITOR LO/DVD VIDE01 ^ TV/DBS; USA^ Canadian, and Australian models TV: other models What cables will I need? • Audio/video cable (not supplied) (1 for each TV or LD player; 2 for each VCR) Yellow White (D White (L) Red(R) Red(R) • Video cable (not supplied) (1 for a TV monitor) Yellow Yellow V If you want to watch high quality video images You can use an S-VIDEO cable for the TV/DBS, LD, Note The signal input from the S VIDEO IN jack is not output to Hookups . ^ The arrow indicates signal flow. TV or Digital Broadcasting System (DBS) tuner DBS tuners can be used with the USA, Canadian, and Receiver (Continued)
diit:
receiver to output die PRE OUT jack signals from the
amplifier's speaker terminals.
The signals output from the PRE OUT jacks are identical
to those output from the speaker terminals of the
You can then connect any pair of speakers (e.g., the
front speakers) to the amplifier's speaker terminals.
Hookups" on page 10.
VIDEO 1/2/3, and MONITOR jacks.
tire normal VIDEO OUT jack. Nor is the signal input from
the VIDEO IN jack output to the S VIDEO OUT jack.
Australian models.