Sony STR-DA80ES - Manual (Page 12)

Getting Started
AC Hookups Before You Use Your Receiver
Setting the voltage selector (only on the
models supplied with the voltage selector)
Cliock tltat tho voltage selector on the rear panel ot tlie
receiver is set to the local power supply voltage. It
not, set the selector to the correct position using a
screwdriver betöre connecting the AC power cord to a
wall outlet.
Connecting the AC power cord
Connect the AC power cord from this receiver and
from your audio/video components to a wall outlet.
If you connect other audio components to AC OUTLET
cm the receiver, the receiver can supply power to the
connected component(s) so you can turn on/off whole
system when you turn on/off the receiver. Note that
only one switched AC cmtlet is supplied with the
Australian model.
AC OUTLET
to a wall
outlet
Caution
Make sure that the total power consumption of the
component(s) connected to receiver's AC OUTLET does not
exceed the wattage stated on the rear panel. Do !H)t connect
high-VN'attage electrical home appliances such as electric
Irons, fans, or T\'s to this outlet.
hc'torc vou start using \ our roceix or, make sure that
\ ou ha\'o:
• Turnod MASTER \’OL to tho loftniost position (0).
• Soloctod tho appropriate speaker svstom. (For
details, see "Selecting the speaker svstem" on
page *->.)
• Set BALANCE to the center position.
Turn on the receiver and check the following indicator.
• Press MUTING on the remote if "MUTING” appears
in the display.
Clearing the receiver's memory
Before you use your receiver for the first time or
when you want to clear the receiver’s memorv, do
the procedure below.
DISPLAY
1 Turn off the receiver.
2
Press down DISPLAY, PANEL UP/DOWN,
and POWER simultaneously.
The contents of ^he memory (preset station
and other parameter settings) are erased.
12