Sony STR-DA80ES - Manual (Page 21)

Dolby Surround Setup
y If you feel the surround effect is inadequate
Do the procedure below to adjust the delay time for the
center and rear speakers.
1 Press SET UP repeatedly to select OTHER SETUP.
2 Use the digital processing control buttons (♦ / ♦ ) to
select CENTER DELAY or REAR DELAY and use the
buttons (♦ / ♦ ) to select the delay time.
Adjusting the speaker volume [X]
Use the remote.while seated in your listening position
to adjust the volume of each speaker.
Note
This receiver incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
SOUND FIELD
ON/OFF
DPC MODE
DICrrAL
PROCESSING
CONTROL
1 Press SOUND FIELD ON / OFF to turn on the
sound field.
2 Press GENRE repeatedly select "DOLBY."
3 Press MODE to select "NORMAL SURROUND"
or "ENHANCED SURROUND." ‘
4 Press DPC MODE repeatedly until the SUR
. indicator lights up.
5 Press TEST TONE.
You will hear the test tone from eadi speaker in
sequence.
From your listening position, use the digital
processing control buttons (A / V ) to select the
parameter to be set and use the buttorrs ( • < / > )
to select the setting so that the test tone can be
heard at the same level from all speakers.
To adjust Select And set between
rear speaker
balance
R E A R L R L (left) and R (right)
rear speaker
level REAR -20.0d6 and +10.0dB
(in 0.5 dB steps)
center speaker
level CENTER -20.0dB and +10.0dB
(in 0 J dB steps)
subwoofer
level SUB WOOFER -20.0dB and +10.0dB
(in 0.5 dB steps)
During adjustment of the respective speaker level/
balance, the test tone is output from the speaker(s)
only.
After adjusting the subwoofer level, the test tone
turns off automatically.
To turn off the test tone
Press TEST TONE.
Notes
• Be sure to select "NORMAL SURROUND" or
"ENHANCED SURROUND" before outputting the test
tone.
21