Sony STR-DA80ES - Manual (Page 6)

Getting Started
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver, ¡f you want to use the
receiver as an amplifier, complete these connections.
For digital connections, see "Digital Component
Hookups" on page 10.
S-LINK CTRL A1 IN
(USA and Canadian models only)
PHONO CD DAT/MD TAPE
What cords will I need?
Audio cords (not supplied) (1 for each CD player and
turntable; 2 for each tape deck, DAT deck, or MD deck)
WMte (L)
Red (R)
Hookups
The arrow indicates signal flow.
CD player
White (L)
Red (R)
Receiver CD player
DAT deck or MD deck
Receiver DAT deck or MD deck
Turntable
Receiver Turntable
DUTPUT
If your turntable has an earth lead
To prevent hum, connect the earth lead to the ih SIGNAL
GND terminal on the receiver.
CONTROL A1 Hookups (USA and Canadian
models only)
• If you have a CONTROL A1 compatible Sony CD player,
tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the
S-LINK CTRL A1 jack on the CD player, tape deck, or MD
deck to the S-LINK CTRL A1 jack on the receiver. Refer
the separate manual "CONTROL-Al Control System" and
the Operating Instructions supplied with your CD player,
tape deck, or MD deck for details.
• If you have a Sony CD changer with a COMMAND
MODE selector
If the CD changer's COMMAND MODE selector can be
switched between CD 1, CD 2, and CD 3, be sure to set the
command mode to "CD 1" and connect the changer to the
CD jacks on the receiver.
However, if you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to "CD 2" and connect
the changer to the VIDEO 2 jacks on the receiver.
Tape deck
Receiver Tape deck