Sony STR-DA80ES - Manual (Page 16)

Receiver Operations
V If the STEREO indicator renuiins off
Press FM MODE even when an FM stereo broadcast is
received.
V If an FM stereo program is distorted
The STEREO indicator flashes. Press FM MODE to
change to monaural (MONO). You will not have the
stereo effect but the distortion will be reduced. To
return to the auto stereo mode, press this button again.
If you cannot tune in a station and the entered
, numbers are flashing
Make sure you've entered the right frequency. If not,
press D.TUNING and reenter the frequency you want.
If the entered numbers still flash, the frequency is not
used in your area.
To watch FM simulcast TV programs
Make sure that you time in the simulcast program on
both the TV (or VCR) and the receiver.
If you enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down
to the closest covered value.
Tuning intervals for direct tuning are:
FM: 50 kHz intervals
AM: 10 kHz intervals (USA and Canadian modeb only;
to change to 9 kHz intervab, see page 32.)
9 kHz intervals (Australian model only)
9 kHz intervals (modeb for all other coimtries; to
Receiving broadcasts'by scanning stations
(automatic tuning)
If you don't know the frequency of thè radio station
you want, you can have the receiver scan all the
receivable stations to locate the one you want.
1 Rotate FUNCTION until the TUNER indicator
lights up.
The Ust received station is tuned in.
Presetting Radio Stations
You'll most likely want to preset the receiver with the
radio stations you listen to often so that you don't have
to tune in the station every time. The receiver can store
a total of 30 FM or AM stations. You can store the
stations on preset numbers combining 3 characters (A,
B and C) and numbers (0-9). For example, you can
store a station as preset number Al, B6, or C9.
PRESET TUNING+/-
IE]
*r
r%
o Ò d 6 6 0 O
. . .
T T f
Ù
SHIFT MEN ORY FUN
2
3 Press FM/AM to select FM or AM.
Press DISPLAY so that the frequency appears in
the display.
1 Rotate FUNCTION until the TUNER indicator
lights up.
The last received station is tuned in.
2 Tune in the station you want.
If you are not familiar with how to tune in a
station, see "Receiving Broadcasts" on page 15.
3 Press MEMORY.
"MEMORY" appears for a few seconds.
Do Steps 4 and 5 before "MEMORY" goes out.
4
Press SHIFT to select a memory page (A, B or C).
Eadi time you press SHIFT, the letter "A," "B" or
"C" appear in the display.
5 Press PRESET + / - to specify the preset number,
and then press MEMORY.
"MEMORY" goes out and the selected station is
preset.
If "MEMORY" goes out before you specify the
preset number, start again from Step 3.
6
Repeat Steps 2 to 5 to preset other stations.
16
Press TUNING -t or -.
Press the + button for a higher station number;
press the - button for a lower one. When you tune
past either end of the band, the receiver
automatically jumps to the opposite end eind
continues scanning in the same direction. Every
time a station is received, the receiver stops
scanning. To continue scanning, press the button
again.