Troubleshooting, Setting up, Storing memory dialing numbers – Sony SPP-AQ25 User Manual

Page 43: Making calls

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Troubleshooting

Problem

Cause/Solution

Setting up

The POWER lamp flashes when
the AC power adaptor is
connected or after a power

interruption.

Press any key.

Storing memory dialing numbers

You hear five short error
beeps and cannot store a
memory dialing number.

• Make sure you follow the procedure in storing the

number correctly (page 21).

• Make sure the number (including the tone and

pause digits, if used) is less than 16 digits.

Making calls

You hear five short error beeps.

Extend the antenna of the base unit vertically.
Move the cordless handset closer to the base unit.
Place the base unit away from noise sources (page

) .

Return the handset to the base unit for a while.

The TALK/ВАТТ LOW lamp
flashes.

Charge the battery pack in the cordless handset for

12 hours (page 15).

You hear no dial tone.

Make sure the RING ON/BATT SAVE switch is set
to RING ON.
Make sure the telephone line cord is securely
connected to the telephone outlet.
Charge the battery pack in the cordless handset
(page 15).

The telephone is always connected
to the wrong number, or not
connected at all, even when the
numbers you dial are correct.

Make sure the dial mode setting is correct (page

16).

General