Sony SLV-420 - Manual (Page 2)

WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
CAUTION
R isk of Et-ECTRC SHOCK
00 NOTOPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK),
NO USER-SERVICEABLE PARTS INSIDE.
REFER servicing TO QUALIRED SERVICE PERSONNEL
This symbol is intended to alert the user to the
presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shodi to persons.
This symbol is intended to alert the user to the
presence of important operating and
mainten£uice (servicing) instructions in the
literature accompanying the appliance.
CAUTION
To prevent electric shock, do not use this polarized AC plug with
an extension cord, receptacle or other outlet unless the blades can
be fully inserted to prevent blade exposure.
Precautions
Safety
♦ Operate the unit only on 120V AC, 60 Hz (SLV-420 ortfy).
* If anything falls into the cabinet, unplug the urut and láve it
dieckfid by qualified personnel before operating it any further.
♦ One blade of the plug is wider than the other for the purpose of
safety and will fit into the power outlet only one way. If you are
unable to insert the plug fully into the outlet, contact your Sony
dealer.
♦ Unplug the unit from the wall outlet if you do not intend to use
it for an extended ¡jeriod of time. To disconnect the cord, pull it
out by the plug, never by the cord.
Installing
• Allow adequate air circulation to prevent internal heat buildup.
• Do not place the imit on surfaces (rugs, blankets, etc.) or near
materials (curtains, draperies) that may block, the venblabon
slots.
• Do not install the unit near heat sources such as radiators or air
ducts, or in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
• Do not install the unit in an inclined position. It is designed to be
operated in a horizontal position only.
• Keep the unit and cassettes away from equipment with strong
magnets, such as miaowave ovens or large loudspeakers.
• Do not place heavy objects on the unit.
• if the urut is brought directly from a cold to a warm location,
moisture may condense inside the VCR and cause damage to the
video head and tape. When you first install the unit, or when
you move it from a cold to a warm location, wait for about one
hour before operating the unit
Information
For customers in the USA
This equipment has been tested and found to comply with the
limits fora Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instnictions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular instahatian. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and orv the user is
encouraged to try to correct the interference by one or more of the
following measures*
• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different fiom
that to which the receiver is connected.
• Consult the dealer or an experienced radlo/TV technician for
help.
You are cautioned that any dianges or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
Caution
Television programs, films, video tapes and other materials may be
copyrighted. Unauthorized recording of such material may be
contrary to the provisions of the copyright laws^ Also, use of this
recorder with cable television transmission may require
authorization &om the cable television transmission and/or
program owner.
Notice to customers vi^o have
purchased this product outside the USA
(SLV^OPXonfy)
Plug adaptor
The plug supplied with your VCR differs from the one that is
showm in the Operating Instructions, Attach the supplied adaptor
onto the phig so that it will fit your power outlet
Power supply
The unit operates on a power supply of 110 to 240 V AC, 50/60 Hi,
and not only on 120 V AC, 60 Hz as indicated in the Operating
Instructions.
Owner's record
The model number is located at the rear and front of the unit and
the serial number on the top. Record these numbers in the spaces
provided below. Refer to them whenever you call upon your Sony
dealer regarding this product.
2 I Introduction
Model No. Serial No.