Sony SPP-SS955 - Manual (Page 13)

Basics
Making calls
1
2
Pick up the handset from the
base phone.
“-4
Press C talk / flash ) and wait
until the TALK/BATT LOW
lamp lights up.
The LINE lamp on the base
phone lights up. You'll then
hear a dial tone.
If you hear five short error
beeps, move closer to the base
phone.
Dial the phone number.
During a conversation, you can
adjust the handset volume.
Follow the procedure described
in the following table.
When you're done talking, press
CD
U
w
G
Additional tasks
( OFF ) or place the handset on
the base phone.
The TALK/BATT LOW lamp
and the LINE lamp on the base
phone go off.
To Do this
Adjust the handset volume During phone conversations, press (
VOLypGM Y Each press of
(VOUPGM ) switches the speaker volume bv one of four levels.
Put a call on hold Press ( HOLD ). The TALK/BATT LOW lamp flashes.
Press ( HOLD1 again to resume the conversation.
Switch to tone dialing
temporarily Press (if-TONE') after vouYe connected.
The line will remain in tone dialing until disconnected.
Notes
• When you increase the sound Volunie, in some cases the back ground noise
may be increased as well. You should adjust the volume accordingly.
• If the handset beeps every second during conversation, move closer to the
base phone; otherwise, the call will be disconnected after one minute.
• While conversing with an outside caller via the base phone, you can't make a
call with the handset. If you press ( talk /FLASH ), you will hear a busy tone. continued
Basics 13^'