Sony GDM-400PS - Manual (Page 13)

Customizing Your Monitor
4 Fine tuning the color temperature
Press the
buttons to select ai\ item and adjust by
pressing the buttons.
I
^
1 I ^ И I ъ ъ
asooKlnooK
швд/«ЖеЮИ$»в.'
G BIAS a BCD a so
в BiASBMEna fa
R GAINOBC^a so
G GAINDBEZia so
в GAIN в ned) a so
Select R (red), G (green), or B (blue) BIAS to adjust the
black level of each color's signal.
Select R (red), G (green), or B (blue) GAIN to .adjust the
while level of each color's signal.
The "SOOOK," "6500K" or "9300K" disappears and the
new color settings are memorized for each of the three
color modes.
The color temperature modes change as follows:
5000K-* 1, 6500K-* 2.9300K— 3
The OSD automatically disappeeurs after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on. The
selected item is reset to the factory settings.
Using the SCREEN On-screen
Display
You can adjust convergence settings to eliminate red or blue
shadows that may appear around objects on the screen.
Adjust the CANCEL MOIRE function to eliminate wavy or
elliptical patterns that may appear on the screen.
Adjust the LANDING function to correct color imbalances
at the four comers of the screen due to influence from the
earth's magnetism.
Once CANCEL MOIRE is adjusted, it will be stored in
memory for the current input signal. All other adjustments
will be stored in memory for all input signals received.
1 Press the MENU button.
The MENU OSD appears.
MENU
2 Press the and buttons to select " QU)
SCREEN," and press the MENU button again.
The SCREEN OSD appears.
ъ ъ
§TOP
I 11 r
ЮВСГГ
□
o" 26 D
о
H CONVEeGENCE
3 Press the buttons to select the item you want
to adjust.
Ezzm
ъ
Select To
m
H CONVERGENCE
adjust the horizontal convergence
(D
V CONVERGENCE
adjust the vertical convergence
(S top
VCONVERTOP
adjust the screen's upper vertical
convergence
о вот
VeasrVER BOTTOM
adjust the screen's lower vertical
convergerux..
(continued)
13