Sony SPP-930 - Manual (Page 3)

12. Unplug this product troni the wall
outlet and reter servicing to
cpalified service personnel under
the following conditions:
A. When the power cord or plug is
damaged or frayed.
B. If liquid has been spilled inta.
the product.
C. If the product has been exposed
to rain or water.
D. If the product does not operate
normally by following the
operating instructions; adjust
only those controls that are
covered by the operating
instructions because improper
adjustment of other controls
may result in damage and will
often require extensive work by
a qualified technician to restore
the product to normal
operation.
E. If the product has been
dropped or the surface has
been damaged.
F. If the product exhibits a distinct
change in performance.
13. Avoid using a telephone (other
than a cordless type) during an
electrical storm. There may be a
remote risk of electric shock from
lightning.
14. Do not use the telephone to report
a gas leak in the vicinity of the
leak.
SAVE THESE
INSTRUCTIONS
CAUTION:
To reduce the risk of fire or injury to persons by
battery, read and follow these instructions.
1. Use only the following type and size battery
pack: SONY BP-T23.
2. Do not dispose ot the batterv pack in a tire.
The cell may explode. Check with local
codes for possible special disposal
instructions.
3. Do not open or mutilate the battery pack.
Released electrolyte is corrosive and may
cause damage to the eyes or skin. U may be
toxic if swallowed.
4. Exercise care in handling the battery in
order not to short the battery with
conducting materials such as rings,
bracelets, and keys. The battery or
conductor may overheat and cause burns.
5. Charge the battery pack provided with or
identified for use with this product only in
accordance with the instructions and
limitations specified in the instruction
manual provided for this product.
6. Observe proper polarity orientation
between the battery pack and battery
charger.
INFORMATION FOR
GENERAL TELEPHONES
1. This equipment complies with Part 68 of the
FCC rules. On the bottom of this
equipment is a label that contains, among
other information, the FCC registration
number and ringer equivalence number
(REN) for this equipment. If requested, this
information must be provided to the
telephone company.
2. The applicable registration jack (connector)
USOC-RJllC or USOC-RJllW is used for
this equipment.
3. This equipment is designed to be connected
to the telephone network or premises
wiring using a compatible modular jack
which is Part 68 compliant.
The FCC compliant telephone cord and
modular plug is provided with this
equipment.
4. The REN is used to determine the quantity
of devices which may be connected to the
telephone line. Excessive RENs on the
telephone line may result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of the
RENs, should not exceed five (5.0). To be
certain of the number of devices that may
be connected to a line, as determined by the
total RENs, contact the local telephone
company.