Cd-o, Setting up a non-preprogrammed component – Sony RM-Y130 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up a Non-preprogrammed
Component
You can program this Remote Commander to learn the
functions of another remote control. Use this function to
operate a component that is not listed in "Component Code
Numbers” with this Remote Commander.
<■
...
.
,
VTR
1 2 3
MDP
1
Set the
slide switch
inside the lid to
VTR3 or MDP.
Place this Remote Commander
and the other component's
remote control directly facing
each other, approximately
5 cm (2 inches) apart.
Approx. 5 cm
{2 inches)
Other component's
remote control
RM-Y130
3
Press and release the
LEARN
button.
The LEARN indicator on this Remote
Commander lights up.
LEARN
CD-O
4
Press and release the button on this Remote Commander
that will learn the function. The LEARN indicator flashes
off, then on, indicating that the Remote Commander is
ready to learn.
5
Hold down the corresponding button on the other remote
control, and release the button when the LEARN indicator
flashes off, then on. If the indicator does not flash, repeat
steps 4 and 5.
If you still cannot get the Remote Commander to work
properly, see "Troubleshooting" on page 19.
6
Repeat steps 4 and 5 to learn other functions.