Setting up the remote commander, About presetting the remote commander, Note – Sony RM-Y130 User Manual
Page 4: Using the remote commander, Notes on using the remote commander
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up the Remote
Commander
Before you can start using the Remote Commander, you must
first set it up. This booklet describes everything you need to
know to set up the Remote Commander, including:
■ Installing the batteries (instructions are on page 5)
■ Presetting the Remote Commander with the codes for your
TV, VCR, MDP and cable box (instructions begin on page 6)
About Presetting the Remote Commander
To set up this Remote Commander to use with other (non-
Sony) manufacturer's TVs, VCRs, MDPs and cable boxes,
you'll need to follow the instructions in this booklet to preset
the Remote Commander with the correct code number.
Note:
The Remote Commander can be set up to operate up to two
components (DSS*, TV, cable box) at a time — unless their
code numbers happen to be the same. For example, you can set
up the Remote Commander to operate two TVs by setting their
codes into the FUNCTION buttons—CABLE and TV. For VCR
and MDP operation, the Remote Commander can be set up to
operate up to four components (VCR, MDP) by switching the
slide switch inside the Remote Commander’s lid.