Citizen Systems Model CMP-10 - Manual (Page 19)

— 17 —
[Caution] • An underline is attached to the full character width. It is, however, not attached to
the part having been skipped by horizontal tab command.
• An underline is not attached to a 90°- right-turned characters.
[Default] n = 0
[See Also] ESC !
[Sample Program]
PRINT #1, CHR$ (&H1B) + “–” + CHR$ (0);
PRINT #1, “AAAAA” ;
PRINT #1, CHR$ (&H1B) + “–” + CHR$ (1);
PRINT #1, “AAAAA” + CHR$ (&HA);
[Print Results]
A A A A A A A A A A
ESC +
[Function] Switch OFF the printer
[Code] <1B>H<2B>H
[Range] None
[Outline] This command is used for switching off the printer from the host.
Sending this command causes the same operation as that by setting the power switch
to off.
ESC – n
[Function] Specifying/ Canceling Underline
[Code] <1B>H<2D>H
[Range] {0 =< n =< 02(Hex)}
[Outline] Specifying/canceling an underline.
• Types of underlines by n value are shown below:
n (Hex) Type
0 Canceling an underline.
1 Specifying an underline for 1-dot width.
2 Specifying an underline for 2-dots width.
>
>
>
>
Underline Canceled
Underline Specified