Tomei Powered P.M.B.C - Manual (Page 3)

3
CAUTION
■ This product has been designed for competition use only and is not to be used on any public roads.
■ This product may pose a risk to the vehicles safety design, which may result in the car being illegal to
be used on public roads in your region.
■ This product is designed for competition use so it must be installed by an experienced qualified
professional with the correct equipment in an appropriate equipped workshop.
■ Protective equipment may be required for the installation process so please ensure there is the
appropriate safety and 1st aid equipment readily available for the installation.
■ Always have the vehicles official workshop service manual to follow the recommended procedures when
installing this product.
■ This product was designed specifically for the engine specified. If the attempt was made to use this
product(s) on another engine other than specified then you will risk of damaging the related parts in
this kit and/or the engine that it is used with.
■ It is best to work on the car when the engine is cold as it will prevent possible burns and or injuries
when the engine is hot.
■ When removing and re-fitting the parts please perform the job with care. Do not use excessive force
on the bolts and parts so as not to cause any damages to the parts and/or related parts.
■ Always have the key removed from the ignition and disconnect the battery's negative terminal before
working on the car.
REQUIRED TOOLS
The following tools are recommended for the installation process.
・General Engine Maintenance Tools ・Workshop Service Manual
KIT CONTENTS
Below is the contents of this kit, with the quantity listed in brackets ().
INSTALLATION
Remove the dropping register coupler and attached the PMBC.
P.M.B.C (1)
P.M.B.C
Remove coupler