Tomei Powered VQ35DE HEAD STUD BOLTS - Manual (Page 7)

NUT TIGHTENING
CAUTION
■ Try not to mark, scratch or damage the mating face of the seat surface & the bore grommet of the
Metal Gasket during installation.
■
T Thoroughly clean the Cylinder Block and Heads surface, to remove any signs of water, oil residue &
unwanted foreign material before installing the Gasket. Give all galleries and passageways a good
① Apply the assembly grease on the supplied Nut
surface face & threads, prior to assembly. (12 sided).
② Follow the numerical order as shown on the left.
(1) Torque to 3.0kg,m (29.4N・m).
(2) Torque to 6.0kgm(58.8N・m).
(3) Torque to 9.5kgm(93.1N・m).
※12 Sided
Thread
Surface
[LEFT BANK]
[RIGHT BANK]
FRONT
FRONT
⑦ ① ③ ⑤
⑥ ④ ② ⑧
⑥ ④ ② ⑧
7
[RIGHT BANK]
FRONT
⑥ ④ ② ⑧
⑤ ③ ① ⑦
7