Reizen RE-50 Amplified Telephone - Manual (Page 14)

14
MEMORY OPERATION
Pause
During the memory storage procedure, you may wish to press R/P
(figure 24) to insert a pause between numbers. (This is sometimes
useful for accessing a switchboard, telephone banking or long distance
dialing). Pressing R/P more than once will increase the pause between
digits.
Each time R/P is pressed, a
'P' will show on the LCD to indicate a 2 second pause in
the dialing sequence. Each pause counts as one digit.
NOTE: When you press * , an upper o appears; When you press #, a lower o appears
Review A Number From The Memory
Press MEMORY (Display shows
ITEM -XX-, XX is the
number of memories stored in the MEMORY - figure
25), enter the first letter of the name (e.g. "R" for
REIZEN): Press number 7 three times and scroll with
until the display shows the name and number that you
want to review.
NOTE: If the number is longer than 15 digits, the number will shift left (1 second)
automatically until the end of the number has been reached. The phone will exit
automatically approximately 15 seconds after the last activity.
Dialing A Numbers From The Memory
There are three different ways to dial a stored speed dial number, depending on your
preference.
Method 1: Pick up the handset and follow the above directions for 'REVIEW A
NUMBER FROM THE MEMORY' until the display shows the name and number that
you want to dial and then press DIAL.
Method 2: Press SPEAKER and choose the desired name in MEMORY (as shown in
Method 1) and then press DIAL.
Method 3: Choose the desired name in MEMORY (as shown in Method 1), and check
the LCD shows the correct information. Press DIAL (the phone enters speakerphone
mode and dials the displayed number).
Figure 24
Figure 25