Dell PowerEdge M605 - Manual (Page 96)

94
Οδηγός για γρήγορο ξεκίνηµα
www
.dell.com | support.dell.com
Μετά την ολοκλήρωση του ελέγχου POST και την εκκίνηση του µεταγωγέα, εµφανίζεται το εξής
πλαίσιο διαλόγου:
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch
configuration, and gets you up and running as quickly as possible.
You can skip the setup wizard, and enter CLI mode to manually
configure the switch. You must respond to the next question to run
the setup wizard within 60 seconds, otherwise the system will
continue with normal operation using the default system
configuration.Note: You can exit the setup wizard at any point
by entering [ctrl+z].
Would you like to run the setup wizard (you must answer this
question within 60 seconds)? [Y/N] y
Βήµα 1:
The system is not setup for SNMP management by default. To manage
the switch using SNMP (required for Dell Network Manager) you can:
o Set up the initial SNMP version 2 account now.
o Return later and setup other SNMP accounts. (For more information
on setting up an SNMP version 1 or 3 account, see the user
documentation).
Would you like to setup the SNMP management interface now? [Y/N] y
To setup the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to access the
switch. The wizard automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell Network
Manager or other management interfaces to change this setting, and
to add additional management system later. For more information on
adding management systems, see the user documentation.
To add a management station:
Please enter the SNMP community string to be used.
{public}:
public
Please enter the IP address of the Management System (A.B.C.D) or
wildcard (0.0.0.0) to manage from any Management Station.
{0.0.0.0}:
192.168.2.1
JR183.book Page 94 Thursday, June 7, 2007 10:07 AM