Dell PowerEdge M605 User Manual

Page 11

Text mode
Original mode

Getting Started Guide

Connect the USB type A connector on the USB cable directly to the switch USB console port.
The PowerConnect M6220 series USB console port is located on the left side of the rear
panel, as shown in Figure 2.

NOTE:

If you are installing a stack of switches, connect the terminal to the Master Switch. When a stack

is powered up for the first time, the switches elect the Master Switch, which may occupy any location in
the stack. If you connect the terminal to a member switch, you will not be able to use the CLI.

Figure 2.

Connecting to the Console Port

latch closed

latch open

JR183.book Page 9 Thursday, June 7, 2007 2:40 PM